Network Device

Switches
Switches are a special type of hub that offers an additional layer of intelligence to basic, physical-layer repeater hubs. A switch must be able to read the MAC address of each frame it receives. This information allows switches to repeat incoming data frames only to the computer or computers to which a frame is addressed. This speeds up the network and reduces congestion.



Bridges
A bridge is used to join two network segments together, it allows computers on either segment to access resources on the other. They can also be used to divide large networks into smaller segments. Bridges have all the features of repeaters, but can have more nodes, and since the network is divided, there is fewer computers competing for resources on each segment thus improving network performance.

Routers
Routers Are networking devices used to extend or segment networks by forwarding packets from one logical network to another. Routers are most often used in large internetworks that use the TCP/IP protocol suite and for connecting TCP/IP hosts and local area networks (LANs) to the Internet using dedicated leased lines.

Gateways
A gateway is a device used to connect networks using different protocols. Gateways operate at the network layer of the OSI model. In order to communicate with a host on another network, an IP host must be configured with a route to the destination network. If a configuration route is not found, the host uses the gateway (default IP router) to transmit the traffic to the destination host. The default t gateway is where the IP sends packets that are destined for remote networks. If no default gateway is specified, communication is limited to the local network. Gateways receive data from a network using one type of protocol stack, removes that protocol stack and repackages it with the protocol stack that the other network can use.